Wire Drawing
Steel (core wire) being the prime raw-material it plays the major role in costing and determining the quality. The Electrode grade Steel wire rod is purchased in the form of Jumbo coils in sizes 5.5mm to 6.5mm this is further drawn into smaller sizes as per the finish electrode wire size requirements.
This unit consists of Descaler, Pointing Machine, Wire Drawing Drums with Die Blocks, Dish Rollers, an Unloading System in the final drum, Butt Welding Machine, Panel Board and Remote Panel The Steel can also be sourced in the form of drawn wire in required sizes if available locally. In this case the wire drawing unit need not be installed in order to keep the total project cost on lower side.
Specification
MODEL | WD30 | WD50 | WD70 | |
---|---|---|---|---|
No of Blocks | 3 in Tandem | 5 in Tandem | 7 in Tandem | |
Dia. of Block | 24"(600 M.M.) Single Die Holder Each Block | |||
Material to be drawn | M.S. Wire Rod | |||
Inlet Wire Size | 5.5mm | 4.00mm | 5.5mm | 5.5mm |
Gear and Worm Ratio | 1:20/1:15 | |||
A.R. Percentage | 22% to 25% | |||
Finishing Speed | 450'/Min | 600'/Min | 650'/Min | |
H.R Recommended | 90HP | 150HP | 210HP | |
Other Equipments included | WIRE POINTING MACHINE, BUTT WELDING MACHINE, DE-SCALLING ATTACHMENT, DIE POLISHING MACHINE, CONTROL PANEL BOARD | |||
Optional Equipment | Dead Block Coiler (DBC) | |||
To Support | 2MT electrode plant | 5MT electrode plant | 8MT electrode plant |